User Manual Part 2
Table Of Contents
- Using SmartDefense
- Using Antivirus and Antispam Filtering
- Overview
- Using VStream Antivirus
- Using VStream Antispam
- How VStream Antispam Works
- Header Marking
- Default Antispam Policy
- Enabling/Disabling VStream Antispam
- Viewing VStream Antispam Statistics
- Configuring the Content Based Antispam Engine
- Configuring the Block List Engine
- Configuring the IP Reputation Engine
- Configuring the VStream Antispam Policy
- Configuring the Safe Sender List
- Configuring VStream Antispam Advanced Settings
- Using Centralized Email Filtering
- Using Web Content Filtering
- Updating the Firmware
- Using Subscription Services
- Working With VPNs
- Overview
- Setting Up Your Safe@Office Appliance as a VPN Server
- Adding and Editing VPN Sites
- Viewing and Deleting VPN Sites
- Enabling/Disabling a VPN Site
- Logging in to a Remote Access VPN Site
- Logging Out of a Remote Access VPN Site
- Using Certificates
- Viewing VPN Tunnels
- Viewing IKE Traces for VPN Connections
- Viewing VPN Topology
- Managing Users
- Using Remote Desktop
- Controlling the Appliance via the Command Line
- Maintenance
- Viewing Firmware Status
- Upgrading Your Software Product
- Configuring a Gateway Hostname
- Configuring Syslog Logging
- Configuring HTTPS
- Configuring SNMP
- Setting the Time on the Appliance
- Using Diagnostic Tools
- Backing Up and Restoring the Safe@Office Appliance Configuration
- Using Rapid Deployment
- Resetting the Safe@Office Appliance to Defaults
- Running Diagnostics
- Rebooting the Safe@Office Appliance
- Using Network Printers
- Troubleshooting
- Specifications
- Glossary of Terms
- Index
Using Web Filtering
540 Check Point Safe@Office User Guide
Configuring Web Filtering Advanced Settings
Note: If the Safe@Office appliance is remotely managed, contact your Service
Center administrator to change these settings.
To configure Web Filtering advanced settings
1. Click Services in the main menu, and click the Web Filtering tab.
The Web Filtering page appears.
2. Next to the Bypass scanning if Service Center is unavailable option, specify
how the gateway should handle Web Filtering when the service is enabled and
the Service Center is unavailable, by doing do one of the following:
• To temporarily block all connections to the Internet, click
.
This ensures that users will not gain access to undesirable Web sites, even when
the Service Center is unavailable.
The button changes to
.
• To temporarily allow all connections to the Internet, click
.
This ensures continuous access to the Internet.
The button changes to
.
When the Service Center is available again, the gateway will enforce the configured
Web Filtering policy.