User Manual Part 2
Table Of Contents
- Using SmartDefense
- Using Antivirus and Antispam Filtering
- Overview
- Using VStream Antivirus
- Using VStream Antispam
- How VStream Antispam Works
- Header Marking
- Default Antispam Policy
- Enabling/Disabling VStream Antispam
- Viewing VStream Antispam Statistics
- Configuring the Content Based Antispam Engine
- Configuring the Block List Engine
- Configuring the IP Reputation Engine
- Configuring the VStream Antispam Policy
- Configuring the Safe Sender List
- Configuring VStream Antispam Advanced Settings
- Using Centralized Email Filtering
- Using Web Content Filtering
- Updating the Firmware
- Using Subscription Services
- Working With VPNs
- Overview
- Setting Up Your Safe@Office Appliance as a VPN Server
- Adding and Editing VPN Sites
- Viewing and Deleting VPN Sites
- Enabling/Disabling a VPN Site
- Logging in to a Remote Access VPN Site
- Logging Out of a Remote Access VPN Site
- Using Certificates
- Viewing VPN Tunnels
- Viewing IKE Traces for VPN Connections
- Viewing VPN Topology
- Managing Users
- Using Remote Desktop
- Controlling the Appliance via the Command Line
- Maintenance
- Viewing Firmware Status
- Upgrading Your Software Product
- Configuring a Gateway Hostname
- Configuring Syslog Logging
- Configuring HTTPS
- Configuring SNMP
- Setting the Time on the Appliance
- Using Diagnostic Tools
- Backing Up and Restoring the Safe@Office Appliance Configuration
- Using Rapid Deployment
- Resetting the Safe@Office Appliance to Defaults
- Running Diagnostics
- Rebooting the Safe@Office Appliance
- Using Network Printers
- Troubleshooting
- Specifications
- Glossary of Terms
- Index
Adding and Editing VPN Sites
Chapter 19: Working With VPNs 595
In this field… Do this…
Destination network Type up to three destination network addresses at the VPN site to which
you want to connect.
Subnet mask Select the subnet masks for the destination network addresses.
Note: Obtain the destination networks and subnet masks from the VPN
site’s system administrator.
Table 120: Authentication Methods Fields
In this field… Do this…
Username and
Password
Select this option to use a user name and password for VPN
authentication.
In the next step, you can specify whether you want to log in to the VPN site
automatically or manually.
Certificate Select this option to use a certificate for VPN authentication.
If you select this option, a certificate must have been installed. (Refer to
Installing a Certificate on page 620 for more information about
certificates and
instructions on how to install a certificate.)
RSA SecurID
Token
Select this option to use an RSA SecurID token for VPN authentication.
When authenticating to the VPN site, you must enter a four-digit PIN code
and the SecurID passcode shown in your SecurID token's display. The
RSA SecurID token generates a new passcode every minute.
SecurID is only supported in Remote Access manual login mode.