User Manual Part 2
Table Of Contents
- Using SmartDefense
- Using Antivirus and Antispam Filtering
- Overview
- Using VStream Antivirus
- Using VStream Antispam
- How VStream Antispam Works
- Header Marking
- Default Antispam Policy
- Enabling/Disabling VStream Antispam
- Viewing VStream Antispam Statistics
- Configuring the Content Based Antispam Engine
- Configuring the Block List Engine
- Configuring the IP Reputation Engine
- Configuring the VStream Antispam Policy
- Configuring the Safe Sender List
- Configuring VStream Antispam Advanced Settings
- Using Centralized Email Filtering
- Using Web Content Filtering
- Updating the Firmware
- Using Subscription Services
- Working With VPNs
- Overview
- Setting Up Your Safe@Office Appliance as a VPN Server
- Adding and Editing VPN Sites
- Viewing and Deleting VPN Sites
- Enabling/Disabling a VPN Site
- Logging in to a Remote Access VPN Site
- Logging Out of a Remote Access VPN Site
- Using Certificates
- Viewing VPN Tunnels
- Viewing IKE Traces for VPN Connections
- Viewing VPN Topology
- Managing Users
- Using Remote Desktop
- Controlling the Appliance via the Command Line
- Maintenance
- Viewing Firmware Status
- Upgrading Your Software Product
- Configuring a Gateway Hostname
- Configuring Syslog Logging
- Configuring HTTPS
- Configuring SNMP
- Setting the Time on the Appliance
- Using Diagnostic Tools
- Backing Up and Restoring the Safe@Office Appliance Configuration
- Using Rapid Deployment
- Resetting the Safe@Office Appliance to Defaults
- Running Diagnostics
- Rebooting the Safe@Office Appliance
- Using Network Printers
- Troubleshooting
- Specifications
- Glossary of Terms
- Index
Using RADIUS Authentication
654 Check Point Safe@Office User Guide
In this field… Do this…
Realm If your organization uses RADIUS realms, type the realm to append to
RADIUS requests. The realm will be appended to the username as
follows: <username>@<realm>
For example, if you set the realm to “myrealm”, and the user "JohnS"
attempts to log in to the Safe@Office Portal, the Safe@Office
appliance will send the RADIUS server an authentication request with
the username “JohnS@myrealm”.
This field is optional.
Timeout Type the interval of time in seconds between attempts to communicate
with the RADIUS server.
The default value is 3 seconds.
RADIUS User
Permissions
If the RADIUS VSA (Vendor-Specific Attribute) is configured for a user,
the fields in this area will have no effect, and the user will be granted
the permissions specified in the VSA.
If the VSA is not configured for the user, the permissions configured in
this area will be used.