User Manual Part 2

Using the Serial Console
678 Check Point Safe@Office User Guide
The Port Setup page appears.
4. In the Assign to drop-down list, select Console.
5. In the Port Speed drop-down list, select the Serial port's speed (in bits per
second).
The Serial port's speed must match that of the attached serial console. The default
value is 57600.
6. In the Flow Control drop-down list, select the method of flow control supported
by the attached device:
• RTS/CTS. Hardware-based flow control, using the Serial port's RTS/CTS lines.
• XON/XOFF. Software-based flow control, using XON/XOFF characters.
7. Click Apply.
You can now control the Safe@Office appliance from the serial console.
For information on all supported commands, refer to the Embedded NGX CLI
Reference Guide.