User Manual Part 2
Table Of Contents
- Using SmartDefense
- Using Antivirus and Antispam Filtering
- Overview
- Using VStream Antivirus
- Using VStream Antispam
- How VStream Antispam Works
- Header Marking
- Default Antispam Policy
- Enabling/Disabling VStream Antispam
- Viewing VStream Antispam Statistics
- Configuring the Content Based Antispam Engine
- Configuring the Block List Engine
- Configuring the IP Reputation Engine
- Configuring the VStream Antispam Policy
- Configuring the Safe Sender List
- Configuring VStream Antispam Advanced Settings
- Using Centralized Email Filtering
- Using Web Content Filtering
- Updating the Firmware
- Using Subscription Services
- Working With VPNs
- Overview
- Setting Up Your Safe@Office Appliance as a VPN Server
- Adding and Editing VPN Sites
- Viewing and Deleting VPN Sites
- Enabling/Disabling a VPN Site
- Logging in to a Remote Access VPN Site
- Logging Out of a Remote Access VPN Site
- Using Certificates
- Viewing VPN Tunnels
- Viewing IKE Traces for VPN Connections
- Viewing VPN Topology
- Managing Users
- Using Remote Desktop
- Controlling the Appliance via the Command Line
- Maintenance
- Viewing Firmware Status
- Upgrading Your Software Product
- Configuring a Gateway Hostname
- Configuring Syslog Logging
- Configuring HTTPS
- Configuring SNMP
- Setting the Time on the Appliance
- Using Diagnostic Tools
- Backing Up and Restoring the Safe@Office Appliance Configuration
- Using Rapid Deployment
- Resetting the Safe@Office Appliance to Defaults
- Running Diagnostics
- Rebooting the Safe@Office Appliance
- Using Network Printers
- Troubleshooting
- Specifications
- Glossary of Terms
- Index
Resetting the Safe@Office Appliance to Defaults
730 Check Point Safe@Office User Guide
• The Safe@Office appliance is restarted.
This may take a few minutes.
• The Login page appears.
To reset the Safe@Office appliance to factory defaults using the Reset button
1. Make sure the Safe@Office appliance is powered on.
2. Using a pointed object, press the RESET button on the back of the
Safe@Office appliance steadily for seven seconds and then release it.
3. Allow the Safe@Office appliance to boot-up until the system is ready.
For information on the appliance's front and rear panels, see the Getting to Know Your
Appliance section in Introduction on page 1.
Warning: If you choose to reset the Safe@Office appliance by disconnecting the power
cable and then reconnecting it, be sure to leave the Safe@Office appliance
disconnected for at least three seconds. Disconnecting and reconnecting the power
without waiting might cause permanent damage.