User's Manual

Creating Rules
120 Check Point Safe@Office User Guide
In this field… Do this…
Custom Service Click this option to specify that the rule should apply to
a specific non-standard service.
The Protocol and Port Range fields are enabled. You
must fill them in.
Protocol Select the protocol (ESP, GRE, TCP, UDP or ANY) for
which the rule should apply.
Ports To specify the port range to which the rule applies,
type the start port number in the left text box, and the
end port number in the right text box.
Note: If you do not enter a port range, the rule will
apply to all ports. If you enter only one port number,
the range will include only that port.
Source Select the source of the connections you want to
allow/block.
To specify an IP address, select Specified IP and type
the desired IP address in the text box.
Destination Select the destination of the connections you want to
allow or block.
To specify an IP address, select Specified IP and type
the desired IP address in the text box.