User's Manual Part 1

Getting to Know Your Safe@Office 500W Appliance
Chapter 1: Introduction 13
Label Description
RESET A button used for rebooting the Safe@Office appliance or resetting the
Safe@Office appliance to its factory defaults. You need to use a pointed object to
press this button.
• Short press. Reboots the Safe@Office appliance
• Long press (7 seconds). Resets the Safe@Office appliance to its factory
defaults, and resets your firmware to the version that shipped with the
Safe@Office appliance. This results in the loss of all security services
and passwords and reverting to the factory default firmware. You will
have to re-configure your Safe@Office appliance.
Do not reset the unit without consulting your system administrator.
USB Two USB 2.0 ports used for connecting USB-based printers
RS232 A serial (RS-232) port used for connecting computers in order to access the
Safe@Office CLI (Command Line Interface), or for connecting an external dialup
modem
WAN Wide Area Network: An Ethernet port (RJ-45) used for connecting your cable or
xDSL modem, or for connecting a hub when setting up more than one Internet
connection
DMZ/
WAN2
A dedicated Ethernet port (RJ-45) used to connect a DMZ (Demilitarized Zone)
computer or network. Alternatively, can serve as a secondary WAN port , or as a
VLAN trunk.
LAN 1-4 Local Area Network switch: Four Ethernet ports (RJ-45) used for connecting
computers or other network devices
ANT 1/
ANT 2
Antenna connectors, used to connect the supplied wireless antennas