User's Manual Part 1

Network Installation
Chapter 2: Installing and Setting up the Safe@Office Appliance 37
Network Installation
1. Verify that you have the correct cable type.
For information, see Network Requirements.
2. Connect the LAN cable:
• Connect one end of the Ethernet cable to one of the LAN ports at the back
of the unit.
• Connect the other end to PCs, hubs, or other network devices.
3. Connect the WAN cable:
• Connect one end of the Ethernet cable to the WAN port at the back of the
unit.
• Connect the other end of the cable to a Cable Modem, xDSL modem or
office network.
4. Connect the power adapter to the power socket, labeled PWR, at the back of the
Safe@Office appliance.
5. Plug the power adapter into the wall electrical outlet.
Warning: The Safe@Office appliance power adapter is compatible with either 100,
120 or 230 VAC input power. Verify that the wall outlet voltage is compatible with
the voltage specified on your power adapter. Failure to observe this warning may
result in injuries or damage to equipment.
Figure 8: Typical Connection Diagram