User's Manual Part 1

Setting Up the Safe@Office Appliance
38 Check Point Safe@Office User Guide
6. In wireless models, prepare the Safe@Office appliance for a wireless
connection:
a. Connect the antennas that came with your Safe@Office appliance to
the ANT1 and ANT2 antenna connectors in the appliance's rear panel.
b. Bend the antennas at the hinges, so that they point upwards.
7. In models with a print server, you can connect network printers as follows:
a. Connect one end of a USB cable to a USB port at the back of the unit.
If needed, you can use the provided USB extension cord.
b. Connect the other end to a printer or a USB 2.0 hub.
Warning: Verify that the USB devices' power requirement does not exceed the
appliance's USB power supply capabilities. Failure to observe this warning may
cause damage to the appliance and void the warranty.
For information on setting up network printers, see Setting up Network Printers on
page 428.
Setting Up the Safe@Office Appliance
After you have installed the Safe@Office appliance, you must set it up using the
steps shown below.
When setting up your Safe@Office appliance for the first time after installation,
these steps follow each other automatically. After you have logged on and set up
your password, the Safe@Office Setup Wizard automatically opens and displays
the dialog boxes for configuring your Internet connection. After you have
configured your Internet connection, the Setup Wizard automatically displays the
dialog boxes for registering your Safe@Office appliance. If desired, you can exit
the Setup Wizard and perform each of these steps separately.