User's Manual Part 3

Controlling the Appliance via the Command Line
392 Check Point Safe@Office User Guide
3. In the upper field, type a command.
You can view a list of supported commands using the command help.
For information on all commands, refer to the Embedded NGX CLI Reference
Guide.
4. Click Go.
The command is implemented.
Using the Serial Console
You can connect a console to the Safe@Office appliance, and use the console to
control the appliance via the command line.
Note: Your terminal emulation software must be set to 57600 bps, N-8-1.
To control the appliance via a console
1. Connect the serial console to your Safe@Office appliance's serial port, using an
RS-232 Null modem cable.
For information on locating the serial port, see Rear Panel.
2. Click Network in the main menu, and click the Ports tab.