User's Manual Part 3

Resetting the Safe@Office Appliance to Defaults
424 Check Point Safe@Office User Guide
To reset the Safe@Office appliance to factory defaults using the Reset button
1. Make sure the Safe@Office appliance is powered on.
2. Using a pointed object, press the RESET button on the back of the Safe@Office
appliance steadily for seven seconds and then release it.
3. Allow the Safe@Office appliance to boot-up until the system is ready
(PWR/SEC LED flashes slowly or illuminates steadily in green light).
For information on the appliance's front and rear panels, see the relevant Getting
to Know Your Appliance section in Introduction on page 1.
Warning: If you choose to reset the Safe@Office appliance by disconnecting the
power cable and then reconnecting it, be sure to leave the Safe@Office appliance
disconnected for at least three seconds, or the Safe@Office appliance might not
function properly until you reboot it as described below.