User Manual
Federal Communications Commission Radio Frequency Interference Statement
Chapter 17: Specifications 453
Federal Communications Commission Radio
Frequency Interference Statement
This equipment complies with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Any changes or modifications to this product not explicitly approved by the
manufacturer could void the user’s authority to operate the equipment and any
assurances of Safety or Performance, and could result in violation of Part 15 of the
FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
SofaWare declares that SBXW-166LHGE-6, ( FCC ID: P6XSBXW-166LHGE-6 )
is limited in CH1~CH11 for 2.4 GHz by specified firmware controlled in U.S.A.
FCC Radiation Exposure Statement for Wireless Models
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. The antenna(s) used for this equipment must be installed
to provide a separation distance of at least eight inches (20 cm) from all persons.
This equipment must not be operated in conjunction with any other antenna.
•This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
•-•Reorient or relocate the receiving antenna.
•-•Increase the separation between the equipment and receiver.
•-•Connect the equipment into an outlet on a circuit different from that
•to which the receiver is connected.
•-•Consult the dealer or an experienced radio/TV technician for help.
•Shielded cables must be used with this equipment to maintain compliance withFCC regulations.
•This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
•FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
•FCC Radiation Exposure Statement for Wireless Models
•This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this equipment must be installed to provide a separation
distance of at least eight inches (20 cm) from all persons.
•This equipment must not be operated in conjunction with any other antenna.
•SofaWare declares that US model of SBXW-166LHGE-6, ( FCC ID: P6XSBXW-166LHGE-6 ) is
limited in CH1~CH11 for 2.4 G band by specific firmware controlled by the manufacturer and is not
user changeable.