Specifications

COMPONENT DESCRIPTION
K1-60 SERIES SAFE DEPOSIT BOX INSTRUCTION GUIDE
After the battery is installed, the system performs a self-check. Due to the difference in battery performance and the unstability
of the lock when it is repowered. If the lock is unusable when it is first time powered, please wait for few seconds after the
self-check is completed.
Knob
External power jack
Keypad
Confirming button(#)
The delete key(*)
Keyhole cover
Emergency keyhole
SECURITY
8
9
1
2
3
4
5
6
7
*
0
#
RIGHT
ERROR
SET
LOW
Locking bolts
Inner cabinet
LED light
Internal battery case
Setting button
Foot mat *2
OPEN
Emergency Key *2
Expansion bolt *2
External power box *1
Accessories
Master Key *2
Warnings：
1.Do not lock the emergency key or external battery box into the cabinet.
2.The initial master code ‘123456’, this code can also be used as the opening password, please be sure
to modify it .
3.lf the safe box is not used for a long time,please remove its battery.
4.Purchase 4 AA batteries in advance, this safe does not contain batteries.
1. Left slide the keyhole
cover to expose the master
keyhole
2.Insert the master key into
the keyhole, turn 90°
clockwise.
3.Insert the emergency key
into the emergency keyhole
turn 65 ° counterclockwise.
4.Turn the knob clockwise to
open the door for the first
time.
5. Remove the internal battery
case cover and install 4 AA
batteries at the right polarity. The
system wil be powered on.
6. Opening when no power
1.Emergency key
2.External power box （plug the external power box in external
power jack, the system will be energized.）
Note: Do not use rechargeable batteries or different brand.
OPENING YOUR SAFE FOR THE FIRST TIME
Note: Please use the emergency key to open the safe for the first time.The operation is as follows
SECURITY
1
2 3
4 5 6
7
*
0 #
RIGHT
SET
LOW
8 0
ERROR
SECURITY
1
2 3
4 5 6
7
*
0 #
RIGHT
SET
LOW
8 0
ERROR
SECURITY
1
2 3
4 5 6
7
*
0 #
RIGHT
SET
LOW
8 0
ERROR
SECURITY
1
2 3
4 5 6
7
*
0 #
RIGHT
SET
LOW
8 0
ERROR
Key Hook
System Setting
Press the setting button (on the inner left side of the door when its opened), then enter the master code “123456” confirm by
“#”, then Start your setup.
STEP 1 Setting the user code
1.press “1” to set the user code, Voice prompts “please enter new code, confirm by #”,Then enter 1-8 digits password (after 8
digits, any input will replace the 8th digit), press the "#" key to confirm.
2.Voice prompts“please re-enter and confirm by #”, At the same time, the "RIGHT" indicator light will blink,then enter the code
again and press the "#" key.
3.If the codes entered twice are the same, the voice prompt "Set success" and the new code is set successfully.
4.If the codes entered twice are not the same, the voice prompt “incorrect user code please re-enter”.
Fingerprint collector