User Manual

62
8.7 Generator Setup
To edit the Generator Setup, press the corresponding button on the Record Setup interface. There
are two independent generators that can be used.
Output Channel Generator
PC Sound Card Generator
Uses the output channels 1 and 2 of the unit.
Uses the sound card line out of the PC.
Embedded generator with tone, white noise
and DC offset. The optional Larson Davis
426A12 signal will output 2 VDC.
Signal comes from a specified wave file. If
necessary the generator will loop the file until
stopped. Press the Edit button to change the
source file and volume.
Can be used for periodic Calibration Check (see
section 8.7.1 p.63) or for general use. The
reference spectrum is saved for further level
comparison.
For general use.
The generation can be scheduled by specifying
the interval, duration and clock alignment.
The generation can be scheduled by specifying
the interval, duration and clock alignment.
PC Sound Card Generator
Output Channel Generator