User Guide Manual

Tenor Data Logger Soft dB inc.
STEP 2: Power the Tenor unit
Connect the power supply to the Tenor unit using the “12Vdc/2.0A” connector at the
rear of the unit. The Board Status LED on the rear of the Tenor unit should turn yellow.
STEP 3: Connection of the Tenor unit to the PC
Connect the Tenor unit to a computer using a USB cable.
Windows will then ask for the Signal Ranger Mk2 Drivers. The Signal Ranger Mk2 is
the DSP (Digital Signal Processor) board on which the Tenor system is based.
The Signal Ranger Mk2 drivers are located in the C:\Program Files\Tenor_24Bit\
USBDriver directory.
Follow the steps in Windows to select the appropriate directory and continue the
installation.
At this point, the Board Status LED on the rear of the Tenor should turn green and the
software can be launched (see section 4.0).
User Manual p. 5