KBS-66K005 Please scan the below QR code to get the video for easy installation. Email:sofucor_service@163.com Email:sofucorceilingfan@163.com Website: www.sofucorfan.
01 Safety Information 02 Remote control manual 15 WARNING 03 Match code 16 Three ceiling installation methods 04 Fans Balance 17 Accessory drawing 05 Care and cleaning 18 Installation procedure 06 Trouble shooting 18 02 Warning: Kindly turn off the power when connecting cables. WARNING: To reduce the risk of personal injury, do not bend the blade brackets (also referred to as flanges) during assembly or after installation. Do not insert objects in the path of the blades.
03 3
04 5 9 5 2 9 2 3 9 3 4
05 5
06 1. Put the screw washers on the screws 2.Use screws to fix the blades to the blade bracket and assemble all the blades first 3.Remove the 16 screws on the motor and prepare to install the blades 4.
06 5.Install all blades 6.Remove the three screws on the side of the motor 7.Turn the fan over 8.
06 9.Remove two screws on the 10.Loosen the screws hanger ball. Remove the hanger ball and bolt 11.Select one downrod and pass 12.
06 13.Tighten the 2 screws to prevent fan shaking during operation 14.Put the decorative cover through the downrod 15.Put the canopy cover through the downrod 16.
06 17.Put the hanger ball through the downrod 18.Insert the bolt 19.Align the screw holes of the hanging ball and boom, use screws to align the screw holes and tighten the screws 20.
06 22.Install the downrod, put the rod ball to the slide-on mounting bracket (both of them have the gaps, align the gap and jam it) 21.
06 23.Connect the wire from the ceiling fan to the receiver ( Red, White, and Black wires) 24.Connect the wire from the ceiling fan to the receiver ( White and Blue wires) 25.Use wire connecting nuts to connect the three ground wires( green) coming from the downrod, receiver and ceiling racket 26.
06 27.Put the receiver into the mounting bracket 28.Loosen the screws (do not remove them) 29.Wrap keyhole slots around the screws, twist clockwise and tighten 2 screws 30.
06 31.Connect the light source with the wires from the motor 32.Adjust the lampshade to align with the holes. Insert three light kit screws, and then tighten them 33.
06 07 Turn off the light and fan at the same time Light on/off Light color temperature switch (Press twice with an interval of 2 seconds to switch a color temperature after turning on the light.) 7 6 Wind Speeds Fan off 3 Kinds of Timing Turning off the light and the fan when the time is over Fan Reverse Mode 7 Natural Wind Mode When the reversible button is pressed, the fan slowly slows down to a stop and then begins to reverse.
08 Pressing and holding this key for 5 seconds.
09 17
10 11 11 Website: www.sofucorfan.
