Instructions / Assembly

IMPORTANT:

Do not remove the protective lm on the polycarbonate

roof panels before installation. Ensure

to put the UV protected side facing the sun. It is a very important procedure; if not followed

as described, your roof will not be covered by the warranty.

PLANNING ASSEMBLY

FOR ALL PRODUCTS

1. It is the consumer’s responsibility to comply with building rules, regulations/

zoning restrictions orders or any other regional restrictions and obtain the

required permits before purchasing this product and installing it.

2. Make sure that every part is in the box before beginning installation.

3. Some parts may have sharp edges; it is recommended to wear gloves,

protection glasses and closed shoes.

4. You must schedule enough time to complete the assembly.

5. You cannot leave the product unattended if it is not fully assembled, even

if bolted to the ground.

6. A minimum of 3 people is required for a safe assembly of the product.

7. Follow each instruction carefully to ensure the strength of the product.

8. To avoid damages to the product and its parts, use the proper tools. Do not

use the product as a support. The use of a ladder is recommended.

9. Keep the instruction manual and the parts list in case of future needs

or references.

10. Do not assemble the product in days of wind or rain.

PRODUCTS WITH POLYCARBONATE ROOF PANELS

TOOLS REQUIRED

Not included in the box.

SAFETY GOGGLES STEPLADDER LEVEL

GLOVES SAFETY HAT PHILLIPS SCREWDRIVER

PAGE 1
PLANNING ASSEMBLY FOR ALL PRODUCTS 1. It is the consumer’s responsibility to comply with building rules, regulations/ zoning restrictions orders or any other regional restrictions and obtain the required permits before purchasing this product and installing it. 2. Make sure that every part is in the box before beginning installation. 3. Some parts may have sharp edges; it is recommended to wear gloves, protection glasses and closed shoes. 4. You must schedule enough time to complete the assembly. 5.