ASSEMBLY INSTRUCTIONS
SAFETY INFORMATION 1. 2. 3. Please gather all of this information BEFORE you contact us. 1. assemble or install the product. 2.Assemble the item on a soft, non-abrasive surface such as carpeting to avoid damage. 3. Estimated Assembly Time: 120 minutes Recommended maximum sitting weight for the sofa set 350 160 Before beginning assembly of product, make sure all parts are present. Compare parts with parts list.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY 1 E F 1 1 1 1 1 HH x Qty. Extra 2 Plastic x Qty. 56 Extra 6 asher Qty. 6 Extra 2 Qty. 28 Extra 1 Qty. Qty. 8 Extra 1 Plastic Qty. 20 Extra 1 Plastic shackle Qty.
ASSEMBLY INSTRUCTIONS FRAME ASSEMBLY 1. Align two holes of the back frame (A). Insert an M6 x 35 L bolt (AA) through M6 washer (CC), with the seat frame (B). Do not tighten completely. Repeat 1 Hardware Used M6 x 35 L Bolt x2 M6 Washer x2 2. Align all four holes of the side frame (C). For each hole, insert M6 x 35 L bolt (AA) through M6 washer (CC), the seat frame (B) and back frame (A). Repeat this step for the oposite side. Do not tighten completely.
ASSEMBLY INSTRUCTIONS FRAME ASSEMBLY 4. Align two upper holes of the back frame ( D). Insert an M6 x 35 L bolt (AA) through M6 washer (CC) with the seat frame (E ). Then align the side holes of the back frame ( D) insert an M6 x 5 L ( ) through M6 washer (CC). Do not tighten completely. Repeat this procedure 4 Hardware Used M6 x 35 L Bolt x M6 Washer x 5. Align two holes of back frame ( D) the oposite side with the side frame ( F) insert an the M6 x 35 L bolt (AA) through the M6 washer (CC).
FRAME ASSEMBLY . Align two upper holes of the back frame ( ). Insert an M6 x 35 L bolt (AA) through M6 washer (CC) with the seat frame (E ). Then align two the side holes of the back frame ( ) insert an M6 x 35 L ( ) through M6 washer (CC). Do not tighten completely. Repeat this procedure M6 x 35 L Bolt x3 M6 Washer x3 . Align two holes of back frame ( ) the oposite side with the side frame ( ) insert an the M6 x 35 L bolt (AA) through the M6 washer (CC).
ASSEMBLY INSTRUCTIONS FRAME ASSEMBLY 10. Attached the products by plastic shackles. 10 Hardware Used HH Plastic shackle X 10 11. Attach four the " L " plastic foot (FF) to the lower corner of the table (G) by using M6 x 25L bolt (ZZ) and Knob (DD). Then tighten all bolts by using allen wrench. 11 Hardware Used ZZ M6 x 40 L Bolt ZZ x4 Knob x4 " L " Plastic Foot x4 ZZ ZZ ZZ ZZ 12. Put the glass (H) on the table (G). And make adjustments. The assembly of this product has been completed.
CTN NO.