Installation & Assembly

ManualsBrandsSol 72 Outdoor ManualsLantern Outdoor Wall LightingBrookland Outdoor Wall Lantern

FOR YOUR SAFETY

ASSEMBL

GENERAL

ARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

teps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

ead instructions carefully.

f you are unclear as to how to proceed,

consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

ixture.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

Unscrew top finial (B) and remove top break (C), and roof from

nipple (E).

STEP

STEP 2:

GROUNDING & UNIVERSAL MOUNTING

BAR LOCK UP (FIG. 2)

*NOT SUPPLIED

*OUTLET BOX

SCREWS (K)

GREEN

GROUNDING

SCREW (L)

MOUNTING

SCREWS (I)

*WIRE

CONNECTOR

UNIVERSAL

MOUNTING

BAR (J)

*NOT SUPPLIED

FIGURE 1

CAP NUTS (N)

*OUTLET BOX

BACK PLATE (M)

CAGE (F)

ROOF (A)

TOP BREAK (C)

TOP FINIAL (B)

NIPPLE (E)

NOTE: This glass is handcrafted, the slight imperfections in

the glass add to the authenticity of the fixture.

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

Summary of content (2 pages)

PAGE 1
Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF .
PAGE 2
INSTALLATION IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Insert fixture mounting screws (I) in threaded holes of universal mounting bar (J). Run screws all the way down to the heads. STEP 2: Place universal mounting bar (J) against outlet box (not suppplied) and screw in place using outlet box screws (K) (not supplied). Be sure the mounting screws are perfectly horizontal so fixture hangs straight. STEP 3: A. Take note of the color of the wire(s) on your fixture.