Instructions

Check the steps below if your Motorcycle doesn’t move after

adding salt water.

1 Make sure motor and gears are installed in right position.

2 Make sure each connector must be set in right position (Ref: )

3 Make sure cut off the burrs of C3 before assembly.(Ref: )

4 Make sure Fuel Cell plate is inserted entirely. (Ref: )

5 Replace a new magnesium sheet if it is eroded as shown below.

6 Make sure that the Fuel Cell plate is placed in the correct sequence and position: air

cathode — nonwoven fabric — magnesium sheet. (Ref: Page 5 )

7 Make sure the air cathode black side is facing up. (Ref: Page 5 )

8 Nonwoven fabric is also used to isolate air cathode and magnesium sheet, make

sure the 2 parts do not come into contact each other or it may cause short circuit.

(Ref: Page 5 )

9 Salt water will easily cause oxidization, scratch oxide from the battery connectors

and also magnesium sheet by slotted screwdriver before reuse. See below figures:

Scratch Here

P11

Magnesium

Sheet

Front Side

The

Opposite Side

Scratch Here

P25