Use and Care Guide

MOBILE APP USER GUIDE SOL-LUX EOS
20 Navigating the App
3.6.2 SERVICE MODE EXTEND & RETRACT
Service Extend and Retract buttons are only available if the awning is in Service Mode. Unlike the Home
screen controls, you must press and hold these buttons to complete the desired motion. Release the button to
stop awning movement. This allows the awning to be positioned for any maintenance required.
Service Extend and Retract button commands take priority over most other commands. These buttons
will operate the awning even if:
 Awning temperature falls below the set Minimum Operable Temperature but is at temperatures
at or above 20ºF (-7ºC).
 Battery charge level is below the minimum charge level for safe operation.
 Awning is retracted due to wind.
 Awning is retracted due to a snow load condition.
3.6.3 FACTORY DEFAULTS
Tap the Factory Defaults button to restore your awning to factory default settings. The following table
lists each setting and its default value.
Setting Description Factory Default Value
Extension (%) 100
Wind Sensitivity 3
Wind Extension Reattempt (minutes) 60
Sun Sensitivity 4
Sun Extension Delay (minutes) 1
Sun Retraction Delay (minutes) 20
Minimum Operable Temperature 40ºF (4ºC)
Temperature Display Units ºF
3.6.4 CALIBRATE
When the battery is connected during installation, the awning will beep 3 times and the motor will briefly
run to ensure that the awning is fully retracted. Once the awning is in proper installation position for at
least one minute without movement, the awning will automatically calibrate. However, if you wish to re-
calibrate the awning for any reason, you can calibrate it directly from your mobile device.
During calibration, the awning learns its full extension limit and collects status information about itself
and surrounding conditions. You can cancel calibration by shaking or moving the awning, disconnecting
the battery, or by pressing either the Extend or Retract Service Mode buttons in the app.
To calibrate using the app, the awning must be in Service Mode. Tap the Calibrate button on the Service
screen. The awning will fully extend and fully retract to complete calibration. If calibration completes
successfully, the calibration message will disappear from the notifications area of the service screen, the
awning will sound a short beep, and the Home screen manual operation buttons will become active. Any long
beep(s) either following or during a calibration attempt indicate calibration failure.
Calibration may fail for the following reasons:
 An obstruction is preventing the awning from fully extending during calibration (the awning will
sound two long beeps).
 The awning is not level (the awning will sound two long beeps).
 The battery charge is too low to complete a calibration (the awning will sound three long beeps).
 The battery temperature is outside of the acceptable range (the awning will sound four long beeps).
 Wind or excessive awning motion was detected during calibration (the awning will sound one long
beep).
If calibration fails due to any of the listed reasons, correct the cause and re-initiate either with the app or
by disconnecting and then reconnecting the battery.