Operation Manual
16
happens, the bag must be changed since the blocked pores reduce the suc-
tion power.
CHANGING THE DUSTBAG 7
AB2850 MODEL
• When the pilot light (30) flashes, the paper bag must be changed. This in-
dicator (30) may come on because of something stuck in the hose or one
of the accessories. To find out if that is the case, unplug the vacuum clean-
er, remove the hose, and turn the vacuum cleaner on again. Turn it on and
if the pilot light (30) does not come on, remove the object from the flexible
pipe or the accessory you are using. Fig. 5
• To change the dust bag (7), unplug the vacuum cleaner and proceed as fol-
lows:
1.- Press the dust bag button (5) and lift the cover.
2.- Remove the bag by sliding the dust bag frame upwards (8), pressing on
the tab that holds the bag in place and put it in the rubbish bin. Fig. 6
• Insert the new bag into the frame (8). Clip the card at the top of the new
bag with the support tab. Insert the bag support along the interior guide
of the bag compartment as far as possible. It is very important for the bag
to be fitted correctly. Make sure that once the bag has been fitted in the
frame the hole in the bag coincides completely with the bag support hole.
Fig. 7
• Close the bag compartment cover.
• The vacuum cleaner is fitted with a safety mechanism that prevents the top
cover from closing if no dust bag has been fitted or if it is fitted incorrectly.
In this case, it is important not to force the cover.
AB2845 / AB2840 / AB2830 / AB2800 MODELS
• When the bag full indicator (14) comes on, the paper bag must be changed.
Fig. 8 This indicator (14) may come on because of something stuck in the
hose or one of the accessories. To find out if that is the case, unplug the
vacuum cleaner, remove the hose, and turn the vacuum cleaner on again.
Turn it on and if the pilot light (14) does not come on, remove the object
from the flexible pipe or the accessory you are using. To change the dust
bag (7), unplug the vacuum cleaner and proceed as follows:
1.- Press the dust bag button (5) and lift the cover.
2.- Remove the dust bag frame completely (8), pressing on the tab that holds
the bag in place to release it and put it in the rubbish bin. Fig. 6
• Insert the new bag into the frame (8). Clip the card on the new bag with
the tab. Slide the bag frame along the bottom guide as far as possible. It is
very important for the bag to be fitted correctly. Make sure that once the
bag has been fitted in the frame the hole in the bag coincides completely
with the bag support hole. Fig. 7
• Close the bag compartment cover.
Aspiradores AB 2800-2850 16 24/7/06, 09:53:20