Instructions for use

12
ENVIRONMENTAL PROTECTION
For environmental protection, when you decide finally to make no further use
of the appliance, consult your Local Authority or Town Council so as to com-
ply with the proper procedure for waste disposal.
MAIN COMPONENTS Fig.1
1. Temperature selector switch (2 temperature positions)
2. Cold air button-switch
3. Push button for attachments
4. Ionizer switch
5. Ionizer pilot light
6. Air intake grille
7. Hanger
8. Non-slip legs
9. Attachments: Fig.2
a) Round brush 20 mm
b) Round brush 38 mm
c) Curling tongs
d) Always Perfect
e) Concentrator
OPERATION
FITTING THE ATTACHMENTS ON THE MOULDER
• To fit any attachment to the central body of the moulder, position the at-
tachment so that the mark ● on the underside lines up with the mark ▲
on the top of the central body. Turn the attachment anticlockwise until you
hear a click. The mark ▼ on the attachment has to be above the mark ▲ on
the central body.
• To remove any of the attachments, you just have to press the “push” button,
turn the attachment clockwise and pull up.
COLD AIR BUTTONSWITCH: Fig.1 2
• This button-switch has two positions. In one of them you just press the but-
ton all the time and cold air will issue as long as you go on pressing.
• The second position consists of pressing the button and sliding it up so that
the switched is fixed, and in this way you will get a continuous flow of air.
E-903 12 17/3/06, 10:19:55