Instruction Manual

MAN-01-00137-1.3 Wi-Fi / ZigBee Antenna and Cable Installation
Wi-Fi / ZigBee Antenna and Cable Installation
Revision History
Revision 1.3, April 2019 – Addition of languages
Revision 1.2, June 2018 - in 'Clipping the Antenna to the Inverter' procedure added steps for switching the inverter
OFF and ON.
Revision 1.1, February 2018 - changed antenna
Introduction
The Wi-Fi/ZigBee antenna-mounting clip and cable are attached to the inverter or connected to a vertical surface with a bracket
(not supplied by SolarEdge).
This document describes how to:
clip the antenna onto the inverter and route the cable. Perform this procedure when the inverter is already mounted
on the wall.
connect the antenna to a vertical surface with a bracket (not supplied by SolaEdge).
Clipping the Antenna to the Inverter
1. After installing the inverter on the wall, unpack the antenna clip and release the cable binding (three parts are connected).
2. Turn OFF the:
inverter ON/OFF switch
inverter Safety Switch (if applicable)
AC breaker connected to the inverter
3. Verify that AC to the inverter is OFF, or disconnect the AC to the inverter by turning OFF the circuit breakers on the
distribution panel. Wait 5 minutes for the capacitors to discharge.
Figure 1: Antenna, clip and cable
4. Insert the clip from the bottom of the inverter between the bracket and the inverter’s rear side.
5. Route the antenna cable upwards along the fins of the inverter side, by threading the clip and RF cable from the bottom of
the inverter between the bracket and the inverter’s rear side.
Figure 2: Inverter side and heatsink
Insert the clip from here
Revision 1.3, April 2019 1