Instructions / Assembly

SolarGoesGreen SGG-Coach-99-V Lamp
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT.
DESCRIPTION
The SGG-Coach-99-V solar lamp post light is the industry’s cutting edge technology for your gas lamp lantern replacement or for
new installations. The lamp is completely solar powered and must be installed in position where the solar panel will receive the
maximum sun per day. The lamp will automatically illuminate at dusk and turn off at dawn.
The light has 10 super bright LED’s, and Li-ion rechargeable battery which is replaceable.
PARTS
1 Complete LED lamp with integrated solar panel, 2- Li-ion Battery, and 1 mount with hardware. *Optional Flat Mount, Optional Pole
Mount, and Optional Wall Mount Kits can be ordered by contacting your retailer to purchase optional or replacement mounting kits.
ATTENTION BEFORE INSTALLATION
 In selecting lamp installation, choose a location where the unit will receive 8-10 hours of unobstructed sunlight during the day.
 Any cover, tree canopy, awning or similar that shades the panel will affect the charging of the battery resulting in a shorter run
time at night. Note: locations for Wall mounted lamps should avoid roof overhangs, eaves, and North facing locations.
 Avoid locations near a night time light source like a porch light or street light. If the panel receives ambient light on it at any time,
it will not allow the automatic day/night sensor to turn the light on.
 The solar light needs at least 8 hours direct sun light charge for first time use.
INSTALLATION
Three-way switch: II (50% Power for winter use) - O (OFF) - I (100% Power for summer use).
When installing the unit, please turn switch to II or I and cover the solar panel head by hand very closely. Please note the delay of 15
seconds for the light to turn on. Then you can start to install the light as follows.
SGG-COACH-99-V-W SGG-COACH-99-V-P SGG-99-COACH-V-F
Wall Mount Flat Post Mount 3” OD Pole Mount
Solar Wall Mount Light- SGG-COACH-99-V-W
 Drill 2 holes on the wall using the wall mount as a template to determine hole location and insert the plastic anchors.
 Attach the LED lamp onto the bracket by spinning threaded stem clockwise into wall mount.
 Attach the bracket on the wall with provided screws.
Solar Flat Mount Light- SGG-COACH-99-V-P
 Drill 2 holes on any flat surface using the flat mount as a template to determine hole location and insert the plastic anchors.
 Attach flat mount to LED by spinning onto threaded stem turning clockwise until seated firmly.
 Fix the LED lamp to the surface by using provided screws firmly.