Instructions / Assembly

Solar Pole Mount Light - SGG-COACH-99-V-F

Note: The original package does not include pole. When you purchase pole, please select 3" O.D

 Invert LED lamp placing solar top on flat surface. Remove nut from threaded stem.

 Slip 3”pole mount over threaded stem being sure to orientate the larger 3” opening pointing away from lamp base so it will fit

over your existing 3” pole. Using pliers and or a deep socket (not provided) thread nut back onto stem until seated firmly in base

of 3” cup.

 Place LED lamp onto pole and firmly drive the three screws ensuring it attaches to the pole safely. Caution must be used to not

over tighten screws.

NOTES AND TROUBLESHOOTING

 If there is not enough sunlight on the solar panel daily, the unit may not charge. Please ensure that the unit is placed in a

position where there is at least 8-10 hours of sunlight a day.

 If there is too much ambient light interference, the unit will not activate as it will assume that it is not dark enough.

 Please keep the solar panel clean by wiping it once every few months with a damp cloth or paper towel. Don’t use strong

detergents or acid based cleaners.

 Rainy and cloudy conditions over continuous days will also affect the charging ability of the light.

 Please note the unit only charges in the II or I position.

 If the light will not illuminate after 2 sunny days, turn on the switch and charge the battery at day time and turn off the switch to

O position to let the lamp not light. For next day, turn the switch on again. Repeat this step for 3 SUNNY days to ensure battery

is fully charged. On 4

morning, return switch to II or I position for normal operation. If the lamp does not illuminate then, the

battery needs to be replaced. NOTE- Lamp does not charge in the O off position.

BATTERY REPLACEMENT

The battery is 3.7V 2000 mAh Li-ion rechargeable battery which is easily replaceable.

If the battery begins to illuminate dimly or for short durations of time and you know that it has had sufficient sunlight on the panel, you

should replace the battery in the following way:

1. Take off the solar panel cover by removing 2 screws on the solar top.

2. Take off the LED plate by removing 4 screws on the plate without damaging cables.

3. Unscrew the black box at the back of LED plate and change with two new 3.7v 2000 mAh Li-ion batteries.

WARNING – Polarity is important. Wrong polarity is dangerous and will destroy the unit.

UPC 850901003484