Instructions / Assembly

ManualsBrandsSolar Goes Green ManualsKitchenIndustrial Solar 50 ft. Range White/Grey Outdoor Flood Light 156-SMD/LED with Optional Motion PIR

SolarGoesGreen SGG-F156-2R

3 Multi-Function Modes

PIR Photo Infrared Motion Controlled Dusk to Dawn (Security Light) or;

Remote Control Dusk to Dawn (Remote Control Light) or;

Continuous Dusk to Dawn Solar Flood Light (Sign Light)

READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT.

SAVE THIS MANUAL FOR FUTURE REFERENCE.

IMORTANT – IDENTIFY THE DIFFERENCE BETWEEN THE TWO WIRES ON THE LIGHT FIXTURE. THE

CONNECTORS ARE THE SAME SIZE, BUT THE WIRES ARE A DIFFERENT SIZE. DO NOT CONFUSE THEM.

See Fig. A1A

1. The larger wire with a 2 terminal connector plug is for the solar panel. Be sure to match

up the flat portion inside of the connector plug in both the male and female side of the

connector plug. Improper installation can damage the connectors. See Fig. A1A

2. The smaller wire with a 3 terminal connector plug is for the Multi-Function set up as

described below. You must plug in one of the following 3 options to operate the light.

This will configure the light for your application. See Fig. A1A

Fig. A1A

Summary of content (4 pages)

PAGE 1
SolarGoesGreen SGG-F156-2R 3 Multi-Function Modes PIR Photo Infrared Motion Controlled Dusk to Dawn (Security Light) or; Remote Control Dusk to Dawn (Remote Control Light) or; Continuous Dusk to Dawn Solar Flood Light (Sign Light) READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT. SAVE THIS MANUAL FOR FUTURE REFERENCE. IMORTANT – IDENTIFY THE DIFFERENCE BETWEEN THE TWO WIRES ON THE LIGHT FIXTURE. THE CONNECTORS ARE THE SAME SIZE, BUT THE WIRES ARE A DIFFERENT SIZE. DO NOT CONFUSE THEM.
PAGE 2
MULTI-FUNCTION MODE SET UP – CHOOSE ONE OF THE 3 FOLLOWING LIGHTING MODES 1. Dusk to Dawn Continuous Operation – Install the supplied Green Plug with White Painted End (Fig. #2) to initially set up the light for Dusk to Dawn operation. There are two wires extending from the light fixture. One wire is smaller and it has 3 connector pins inside of the female plug. This is the connector for the Green Plug. Be careful to align the flat slotted portion inside both the male and female connector plug.
PAGE 3
OPERATION 1. Light Fixture - Be sure the fixture switch is in the “on” position, indicated by straight line, and charge for at least 8 hours in full sunlight exposure. Note: battery will charge in both the ON and OFF position. 2. PIR Sensor - Sensitivity, lighting time and ambient luminance can be readjusted by selector buttons located at the PIR controller.
PAGE 4
④ ③ ① ③ ② ⑤ ⑦ ⑥ Fig.3 Take a screw driver and take out the four screws ① that hold the back housing ② onto the light. Take off back housing gently to avoid damaging the wires. Unscrew the two screws ③ and remove the strap ④ that holds the battery down. Pull out the connector ⑤ connecting to circuit board ⑥ from the battery ⑦. Take off the old battery. Replace new Li-ion battery with same size and mAh rating. Please contact your for purchase of a replacement battery. 7.