Product Manual

OPERATING THE UNIT AS AN AIR COMPRESSOR (Model No. 3001 Only)
Warning: DO NOT INFLATE TIRES OR FLIP AIR COMPRESSOR “ON/OFF” SWITCH WHILE THE UNIT
IS PLUGGED INTO 110 AC POWER SOURCE!
1. Snap air chuck on tire valve stem (some wheel covers may require use of valve stem extension).
2. Flip “ON/OFF” air switch on front panel to “ON” position.
3. Tire will inflate to preset pressure and compressor will shut off.
4. Disconnect air chuck from tire valve stem (compressor will come on again).
5. Flip “On/Off” air switch on front panel to “Off” position.
6. See Compressor section below to adjust shut off pressure.
Adjusting the Compressor Shut Off Pressure
1. Remove back panel by removing
(2) 1/4” – 20 bolts securing panel.
2. Locate the pressure switch
and set screw (center of switch).
3. When adjusting shut-off pressure,
turn no more than 1/2 turn between settings.
4. To increase pressure setting, turn
clockwise (1/4 turn = approximately 4 lb.).
5. To decrease pressure setting, turn counter-
clockwise (1/4 turn = approximately 4 lb.).
6. Check pressure setting by inflating a tire and
checking tire pressure with an air gauge.
If more adjustment is necessary, return to step 4 or 5.
7. Secure back panel with (2) 1/4” – 20 bolts bolts.
RECHARGING THE UNIT
The charging circuitry in your unit utilizes a multi-phase, smart charging routine for more beneficial charging of
the onboard battery for enhanced reserve capacity and longer battery life.
The charging circuitry features the ability to properly charge both Standard Flooded and AGM batteries. This is
an important enhancement, as AGM batteries are designed for better cycling (charge/discharge) longevity and
are spill-proof, which is important in a mobile application such as this.
• All units ship with the charging mode set to the Standard Flooded Battery charging setting. This setting
should be changed if you choose to install an AGM battery in your unit. To change this setting, locate the
control switch on the charging board inside the unit and change the setting to AGM mode.
• Take care to ensure that cables and clamps are properly stored and secure and that the AC power cord is
not damaged in any way.
• Connect the AC power cord to a properly grounded outlet.
• The charging routine is fully automatic and will bring the onboard battery to full charge and then turn off. The
charger will turn back on if the battery discharges for any reason.
• The charger can be left connected to the AC outlet with no harm to the onboard battery.
Air
Hose
Connector
Pressure
Set
Screw
Compressor