Datasheet

Table Of Contents

Kit

Linear Servo Adapter

Kit includes:

a. 1N4007 rectifier diodes (used to drop voltage) x 2

b. Linear servo adapter PCB

c. 3 pin JST connector, 1.5mm spacing

d. Male pin strip, 3 positions (interfaces to female

servo cable)

Mount the diodes upright, with the leads

nearest the silver bands going to the pads

closest to the set of 5, exactly like the

picture.

If desired, Solder the 3 pin header right

beside the diodes (not pictured).

As the PCB solder pads are tiny, a fine-tip

soldering iron is helpful! Start by bending the legs

into “stand up” position, like in the photo.

You can use your fingers, but your trusty pair of

needle nose pliers will do a better job!

Stripe band on top

3-Pin header

installed here

www.solarbotics.com

1-866-276-2687

Document Revision: July 20 2012

SKU: 22091

http://www.solarbotics.com/products/22091

Linear Servo AdapterLinear Servo Adapter

KitKit

Assembled kit

PAGE 1
Linear Servo Adapter Kit a b c d Kit includes: a. 1N4007 rectifier diodes (used to drop voltage) x 2 b. Linear servo adapter PCB c. 3 pin JST connector, 1.5mm spacing d. Male pin strip, 3 positions (interfaces to female servo cable) it dk le mb e Ass As the PCB solder pads are tiny, a fine-tip soldering iron is helpful! Start by bending the legs into “stand up” position, like in the photo.
PAGE 2
Install the JST connector with the tab cutouts of the connector facing in toward the diodes. Backwards won’t work! Spread the pins out a bit to assist soldering these snug pads. If you’re using the 3 pin header, use a 15005 / 15007 female-to-female servo cable to adapt your linear servo to a controller board.