Datasheet

220
90
Install the JST connector with the tab cutouts of the
connector facing in toward the diodes. Backwards
won’t work!
If you’re using the 3 pin header, use a 15005 / 15007 female-to-female servo
cable to adapt your linear servo to a controller board. Otherwise, solder on a
15000 standard servo header cable to the board, and you are good to go!
Solarbotics Ltd.
3740D - 11A Street NE, Suite 101
Calgary, Alberta T2E 6M6
Canada
Toll Free: 1-866-276-2687
International: [phone]
Fax: [phone]
Made in Canada
Visit us online for more info and cool stuff:
www.solarbotics.com
Spread the pins
out a bit to
assist soldering
these snug
pads.
VS-19 Pico Linear Servo
Super small, and compact, but limited to 3.6V
operation. Ideal for tiny back’n’forth motion.
150
05
3-Pin Servo Patch Cable
Female/Female ends, 35cm (14”) long - ideal for
connecting your Servo adapter to a project board.
1
5
00
0
3-Pin Servo Cable (single ended)
Wire up your accessories with the Ground/Power/Signal
servo standard.
SB-GVS Sensor Shield for Arduino
Make interfacing to your Arduino-compatible
easy with servo cables to your accessories.
3
9
23
0