Instructions

Parts List

1 x SB-FireFly printed circuit board (PCB)

1 x Pre-programmed Attiny85 with 8Mhz internal oscillator

2 x Green SBLED

1 x Blue SBLED

1 x SWT10 switch (mode/power pushbutton)

1 x 47ohm resistor (yellow / violet / black) for LED current limiter

1 x 10kohm resistor (brown / black / orange) for reset pull-up

1 x 8-pin DIP carrier

1 x ISP 3x2 male header (programming)

1 x 2032 coin cell battery

1 x 2032 coin cell battery holder

1 x 6 pin Female Header

1 x 3 pin Female Header

1 x 0.1uF Capacitor
We strongly suggest you count the parts in your kit to make sure
you have all the parts listed (c’mon - there’s barely a handful of
parts, so count them!). If anything is missing, contact Solarbotics
Ltd. for replacement parts information.
Tools & Materials Needed (The 4 ‘S’s):
- Soldering iron
- Solder
- Safety glasses
- Side/flush cutters
SB-FireFly Manual
3