Instructions

ASSEMBLY
GraviTrack Solar Marble Machine Kit
2
1. Assembling the Linkage
Step
Get the linkage base (A) from Panel 3.
Locate the small curve (B), small arm (C),
and 3 x large curves (D). Use the
screwdriver to push out any sticking
cutouts.
Assemble the pieces to the linkage base as shown. Make sure
the larger of the two holes of the small arm (C) is used to
attach it to the base (2x ¼” screw, 1x ½” screw).
Tighten the screws so the pieces can move without
friction but stay flat against linkage base. So make
them tight but so snug they can’t move freely.
1.1
1.2
Assemble spacer #1 (F), and medium
arm (G) and from Panel 3, and the large
arm (E) from Panel 2.
Remove any cutouts and attach to the
linkage base as shown (1x ¼” screw, 1x
⅜” screw).
1.3
All the laser cut parts are labeled and marked per panel. It’s now the simple process
of find, prepare, and assemble!
C
(A)
(B)
(D)
Larger hole
½”
¼”
( )
(E)
(F)
(G)
¼”
⅜”
Smaller hole
From panel 3, get Triangle #1 (H) and
Triangle #2 (I), and attach to the linkage
base as shown.
Install Triangle #1 (H) on the bottom
using the 3/8” screw.
1.4
(H)
(I)