Instructions

ASSEMBLY STEPS

2. Assembling the Tower

Step

Remove the 4 tower bottom sections

(1) and remove cutouts. Apply glue to

each highlighted area, and fit each edge

together to create the three-

dimensional tower bottom.

2.1

All the laser cut parts are labeled and marked on the panel. Assembly is a simple

process of find, prepare, and assemble!

Remove the large platform (2) and

remove cutouts. Add glue to the indicated

areas and push the large platform down

onto the “fingers” of the tower bottoms.

2.2

You may need to wiggle the tower bottoms a

bit to get the fingers into the holes of the large

platform.

Do your best to complete all the

assembly before the glue dries. Being

able to wiggle components while putting

this together speeds construction.

Remove the 4 x tower middle section (3)

and remove cutouts. Add glue to each

area indicated and fit the edges together

to create the three-dimensional tower

middle.

2.3

Don’t pause here - complete step 2.4 before

letting the glue from this step completely cure.

The Paris Flyer CarouSol Kit