Manual

8
3.7
Remove the Bottom submarine
rib (18) and remove cutouts. Insert the
rib into the ring slots, making sure it is
fully seated.
3.8
Remove the remaining 4
submarine ribs (19) and insert them
into the slots of the sub rings, ensuring
they are fully seated.
The top ribs may install easier if you slide the
motor fin (17) out just a bit.
4.0
4. Assembling the Balance Arm
Step
ASSEMBLY STEPS
(22)
(21)
(20)
Locate the balance arm (20), 2
solar panel holders (21), and
connector peg (22).
Mount the solar panel holders
into the slots on the balance
arm. Use the connector peg
to pin the submarine
to the balance arm as
shown (peg through sub,
then into balance arm).
Install the spin point and screw into
the balance arm slot. Finger tighten
them together into the slot.