Sumovore Manual

The Solarbotics Sumovore
Building the Mainboard Electronics - 4
Step 18 & 19 - Front Pins and Terminal Blocks - IMPORTANT!:
Well, we’re done with the top of the PCB (for now). These next two steps take place on the underside of mainboard, so even if
the markings for the parts are on the top of the board, they’re installed on the underside. Don’t get this wrong!
Step 18: Front Pins (2 sets) are installed underneath points ‘P1’ & ‘P2’, BUT get installed on the other side!
Step 19: Terminal blocks (2 sets) install here on bottom side, with side holes pointing out the back
Steps 18: Front Pins Installed Steps 19: Terminal Blocks Installed
Mainboard PCB Finished! There - you have pretty much finished the mainboard. You will have to adjust the angle of the front
pins to suit the front plate, but we’ll take care of that when it’s time to install the front plate.
Get up from your chair, go raid the fridge for a snack (wash your hands first, lead-boy), and enjoy having completed the first
task in building your Sumovore!
Note: Slide the
Terminal blocks
together to make
one module!