Installation Guide

2.
Determine the mounting location, on a wall, stud framing or pole. Maintain the following minimum clearance areas between the holder and other objects:
l 8" (20 cm) from the top and sides of the holder
l 24" (60 cm) - 4 ft (1.2 m) from the bottom of the holder
3. Position the holder against the wall/ pole and mark the drilling hole locations.
4. Drill the holes.
5. Position the EV Charger Cable (with the plug at the top) in the groove of the holder and attach the holder to the wall using the screws (See Figure 2). This
allows cable strain relief.
6.
Verify that the bracket is firmly attached to the mounting surface.
Figure 2: Cable connection
7.
Hang the cable on the holder. To avoid damage to the cable, do not exert pressure on the cable.
Figure 3: Inverter with EV charger
8. Activate and configure the EV Charger as described in the next section.
NOTE
Keep the dust-cap closed when the charger is not in use.
EV Charger Cable Installation and EV Charger Configuration MAN-01-00445-1.1
2
EV Charger Cable Installation and EV Charger Configuration