Installation Guide

Specifications
EV Charger Connector SAE J1772-2009
Charging Cable Length 25 ft./ 7.6 m (15 ft./ 4.6 m option)
Charging Cable Weight 12.5 lb./ 5.7 kg (7.7 lb./ 3.5 kg for the 15 ft./ 4.6 m option)
Holder Weight 0.6 lb. / 300 gr
Charging Instructions
1. Verify that the green LED at the bottom of the inverter is ON indicating that the EV Charger is ON and ready to charge.
2. Hold the EV Charger plug and unwind the cable from the holder.
3.
Connect the EV Charger plug tothe charging socket of the vehicle and push firmly until it clicks into the socket. The inverter will sound 1 short beep and the
blue LED will turn on (the green LED turns off) to indicate a proper connection.
The charging starts automatically, indicated by 2 short beeps and 1 long beep and the blue LED blinking.
When the charging is complete, the blue LED stops blinking and is steadily on.
4. Press the EV Charger plug latch and pull it from the EV charging socket.
5. Wind the EV Charger cable on the holder and hang the EV plug.
For all LED indications refer the EV Charging Inverter Installation Guide.
Specifications
EV Charger Cable Installation and EV Charger Configuration MAN-01-00445-1.1
5