Installation

MAN-01-00082-1.0

SolarEdge Power Optimizer – Zep Compatible™

Installation Guide

This installation guide describes how to install the Zep Compatible™ power optimizer on a Zep Compatible frame. For detailed

instructions on how to properly install Zep Solar products, please visit the Zep Solar website.

Required Accessories

Zep AC/DC Cable Clip or Zep Wire Clip, Type A

Mounting Instructions

Installation of SolarEdge power optimizers begins with module preparation which is completed on the ground prior to

carrying modules onto the roof.

For North-America - Installation of the Zep Compatible SolarEdge power optimizers create automatic ground-bond

connection with Zep Compatible modules, eliminating the need for any additional bonding hardware.

The power optimizers can be installed on either the long edge or short edge of the module.

1 Connect the DC+ and DC- from the module to the

power optimizer inputs.

2 Loop the module wire leads through the bracket to

manage the excess wire.

3 Place the power optimizer on the Zep Groove of the

module

4 Firmly press the bracket with your palm to install

PAGE 1
SolarEdge Power Optimizer – Zep Compatible™ Installation Guide This installation guide describes how to install the Zep Compatible™ power optimizer on a Zep Compatible frame. For detailed instructions on how to properly install Zep Solar products, please visit the Zep Solar website.
PAGE 2
Array Instructions Once the PV modules and the power optimizers have been mated, the units are ready to be transported to the roof. Zep Compatible PV modules are installed by resting the Zep Groove on leveling feet or other application-specific attachment devices, and rotating downward. 1 Install modules as in a standard Zep Solar array. 2 Use Zep Wire Clips to manage DC output wires from SolarEdge power optimizers.