Installation Guide

Verifying the Meter Connection
Verifying the Meter Connection using SetApp
To verify the meter connection using SetApp:
1. From the SetApp main menu, select Status.
2. On the Status page, scroll down to the Communication status section. Check that
one or more meters is connected to the RS485-1 or RS485-2 bus.
Communication
LAN
Connected
RS485-1
Modbus
2 of 2
RS485-2
SE Slave
None
Cellular
N/A

ZigBee
NC
3.
Continue scrolling to the Meters section. If there is more than one meter/function,
there is a status sub-section for each one. An example appears below. The following
Energy Meter with Modbus Connection MAN-01-00270-1.3
26 Device Configuration