Installation Manual

Verifying the Connection

Afterconnectingandconfiguringacommunicationoption,performthefollowingstepsto

checkthattheconnectiontothemonitoringserverhasbeensuccessfullyestablished.

1. Closetheinvertercover:Attachtheinvertercoverandsecureitbytighteningthescrews

withatorqueof9.0N*m/6.6lb.*ft.Forpropersealing,firsttightenthecornerscrews

andthenthetwocentralscrews(seealsoFigure 30).

2. TurnONtheACtotheinverterbyturningONthecircuitbreakeronthemaindistribution

panelandturningontheSafetySwitch.

3. WaitfortheinvertertoconnecttotheSolarEdgemonitoringportal.Thismaytakeupto

twominutes.

AstatusscreensimilartothefollowingappearsontheLCDpanel:

V a c [ V ] V d c [ V ] P a c [ w ]

2 4 0 . 7 1 4 . 1 0 . 0

P _ O K : 0 0 0 / 0 0 0 < S _ O K >

- - - - - - - - - - - - - - - O F F

S_OK:IndicatesthattheconnectiontotheSolarEdgemonitoringportalissuccessful.IfS_OK

isnotdisplayed,refertoErrors and Troubleshooting on page 83.

SolarEdge-Installation Guide MAN-01-00002-4.0

Verifying the Connection