Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Support and Contact Information
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Technical Specifications - Single Phase Inverters with HD-Wave Technology (No...
2.
Toallowproperheatdissipation,maintainthefollowingminimumclearanceareasbetweenthe
inverterandotherobjects:
Figure 16: Clearance areas
3. Positionthemountingbracketagainstthewall/poleandmarkthedrillingholelocations(referto
MechanicalSpecificationsonpage58forinverterandmountingbracketdimensions).
4.
Drilltheholesandmountthebracket.Verifythatthebracketisfirmlyattachedtothemounting
surface.
5.
Hangtheinverteronthebracket:
a. Lifttheinverterfromthesides,orholditatthetopandbottomoftheinvertertolifttheunitinto
place.DonotliftholdingtheSafetySwitchasitmaybedamaged.
b. LowertheinverterontotheU-shapedindentations,asshownbelow.Lettheinverterlayflat
againstthewallorpole.
c.
Insertthetwosuppliedscrewsthroughtheouterheatsinkfinonbothsidesoftheinverterand
intothebracket.Tightenthescrewswithatorqueof4.0N*m/2.9lb.*ft.
Figure 17: Hanging the inverter on the brackets
Chapter 3: Installing the Inverter
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
27