Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Support and Contact Information
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Technical Specifications - Single Phase Inverters with HD-Wave Technology (No...
6.
Optionally,securetheSafetySwitchbrackettothewall/pole,using1-3screws:
NOTE
In case of inverter replacement with the Safety Switch still mounted, it is recommended to use all
3 holes.
a.
MarkthelocationofthebracketscrewfortheSafetySwitch,andoptionallythetwo
additionalbracketholes.
Figure 18: Safety Switch bracket
b. Removetheinverterfromthewall/pole.
c. DrilltheholefortheSafetySwitchbracket.
d. Hangtheinverteronthemountedbrackets.
e. FastentheSafetySwitchbracketusingastandardbolt.
7. Insertthescrewsatthetopoftheinverterbracketsandfastenthebracketstogether.
8. Verifythatallthebracketsarefirmlyattachedtothemountingsurface.
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
28
Mounting the Inverter