Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Support and Contact Information
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Technical Specifications - Single Phase Inverters with HD-Wave Technology (No...
Figure 23: Communication board connectors
Removing the Inverter Cover
Iftheinvertercoverisnotalreadyremoved,usethefollowingprocedureforcoverremoval.
To remove the inverter cover
1. TurntheinverterON/OFF/PswitchtoOFF.Wait5minutesforthecapacitorstodischarge.
2. TurntheSafetySwitchtoOFF.
3. DisconnecttheACtotheinverterbyturningOFFthecircuitbreakersonthedistributionpanel.
4.
Opentheinvertercover(seeFigure24).
CAUTION!
When removing the inverter cover, make sure not to damage the internal components. SolarEdge will
not be held responsible for any components damaged as a result of incautious cover removal.
ATTENTION!
Lors du retrait du couvercle, assurez-vous de ne pas endommager les composants internes. SolarEdge
ne peut être tenue pour responsable des composants endommagés à la suite d'une imprudence dans le
retrait du couvercle.
Figure 24: Removing the inverter cover
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
46
Removing the Inverter Cover