Install Manual

To connect the Ethernet cable:
1. RemovetheinverterandSafetySwitchcoversasdescribedinRemovingtheInverterCoveronpage46.
2. Openthecommunicationgland#1.
CAUTION!
The gland includes a rubber waterproof fitting, which should be used to ensure proper sealing.
ATTENTION!
Le cote interne du gland contient une rondelle qui doit être utilisée pour une bonne étancheïté.
3. Removetheplasticsealfromoneofthelargeopenings.
4. RemovetherubberfittingfromtheglandandinserttheCAT5/6cablethroughtheglandandthrough
theglandopeningintheinverter.
5. InsertthecablethroughtheopeningintheSafetySwitchtowardsthecommunicationboard.
6.
Pushthecableintothecutopeningoftherubberfitting.

 
Figure 26: Communication glands and rubber fitting
CAT5/6standardcableshaveeightwires(fourtwistedpairs),asshowninthediagrambelow.Wirecolors
maydifferfromonecabletoanother.Youcanuseeitherwiringstandard,aslongasbothsidesofthe
cablehavethesamepin-outandcolor-coding.
RJ45 Pin #
Wire Color
1
10Base-T Signal
100Base-TX Signal
T568B T568A
1 White/Orange White/Green Transmit+
2 Orange Green Transmit-
3 White/Green White/Orange Receive+
4 Blue Blue Reserved
5 White/Blue White/Blue Reserved
6 Green Orange Received-
1
The inverter connection does not support RX/TX polarity change. Supporting crossover Ethernet cables depends on the
switch capabilities.
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
48
Creating an Ethernet (LAN) Connection