Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Support and Contact Information
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Technical Specifications - Single Phase Inverters with HD-Wave Technology (No...
Appendix C: Replacing and Adding System
Components
NOTE
If you are permanently disassembling the installation or part of it, make sure to use the disposal
methods dictated by local regulations.
Replacing an Inverter
1. TurnOFFtheinverterON/OFF/Pswitch,andwaituntilthegreenLEDisblinking,indicatingthatthe
DCvoltageissafe(<50V),orwaitfiveminutesbeforecontinuingtothenextstep.
2. DisconnecttheACtotheinverterbyturningOFFtheACcircuitbreakerofthedistributionpanel.
3. TurnOFFtheSafetySwitch.
4. OpentheSafetySwitchcover:ReleasethefourAllenscrewsandremovethecover.
5. OpentheinvertercoverasdescribedinRemovingtheInverterCoveronpage46.
6. DisconnecttheDCandACcablesfromtheSafetySwitch.
7.
DisconnectthewiresconnectedbetweentheinverterandtheSafetySwitch:
l Antennacablefromthecommunicationboard
l DCandACwiresintheSafetySwitch
l Groundingcable
8.
DisconnecttheSafetySwitchfromtheinverterbyopeningthetwoclipssecuringtheSafetySwitch
totheinverter:Carefullyplaceascrewdriverbetweentheclipandtheenclosureandpulltheclip.
Figure 37: Disconnecting the Safety Switch from the inverter
Appendix C: Replacing and Adding System Components
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
59