Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Support and Contact Information
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Technical Specifications - Single Phase Inverters with HD-Wave Technology (No...
9.
Removethescrewssecuringtheinvertertothemountingbracketsandlifttheinverterfromthe
mountingbracket.
Figure 38: Mounting brackets
NOTE
If you remove the old inverter and do not immediately install a new one, then:
o
Lock the Safety Switch in the OFF position using a lock on the switch.
o
Secure the Safety Switch bracket to the wall/pole, using 3 screws
o
Use insulation tape to isolate each of the AC and DC wires.
o
Seal the open conduits using duct tape.
o
Install the Safety Switch sealing cover supplied with the inverter and secure with retaining clips.
10. Placethenewinverteronthemountingbracketsandsecureitusingthescrews.
11. InsertthewiresfromtheSafetySwitchintotheopeningsintheinverterandtheferritebead.
12. FastenthetwoclipssecuringtheSafetySwitchtotheinverter.
13. Reconnectthecables:FollowtheinstructionsofInstallingtheInverteronpage21.
14. ClosetheinverterandSafetySwitchcovers.
15. PerformthecommissioningstepsasdescribedinActivating,CommissioningandConfiguringtheSystem
UsingtheInverterSetApponpage33.
Replacing the Safety Switch
1. TurnOFFtheinverterON/OFF/Pswitch,andwaituntilthegreenLEDisblinking,indicatingthatthe
DCvoltageissafe(<50V),orwaitfiveminutesbeforecontinuingtothenextstep.
2. TurnOFFtheSafetySwitchandtheACbreakerofthedistributionpanel.
3. OpentheSafetySwitchcover:ReleasethefourAllenscrewsandremovethecover.
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
60
Replacing the Safety Switch