Install Manual

4. OpentheinvertercoverasdescribedinRemovingtheInverterCoveronpage46.
5. DisconnecttheDCandACcablesfromtheSafetySwitch.
6.
DisconnectthewiresconnectedbetweentheinverterandtheSafetySwitch:
l Antennacablefromthecommunicationboard
l DCandACwiresintheSafetySwitch(withtheferritebead)
l Groundingcable
7.
OpentheSafetySwitchbracketscrews.
Figure 39: Connection Unit bracket
8.
DisconnecttheSafetySwitchfromtheinverterbyopeningthetwoclipssecuringtheSafetySwitch
totheinverter:Carefullyplaceascrewdriverbetweentheclipandtheenclosureandpulltheclip.
Figure 40: Disconnecting the Safety Switch from the inverter
9. DetachtheSafetySwitchfromtheinverter.
10. PlacethenewSafetySwitchandsecureittotheinverterusingtheclips.
11. InsertthewiresfromtheinverterintotheopeningsintheSafetySwitchandtheferritebead.
12. Reconnectthecables:FollowtheinstructionsofInstallingtheInverteronpage21.
13. Closetheinvertercover.
14. FastentheSafetySwitchbracketusingastandardbolt.
15. PerformthecommissioningstepsasdescribedinActivating,CommissioningandConfiguringtheSystem
UsingtheInverterSetApponpage33.
Appendix C: Replacing and Adding System Components
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
61