Installation Guide

Figure 13: Mounting bracket
NOTE
Make sure the mounting surface or structure can support the weight of the
inverter and bracket, and make sure that it spans the width of the bracket.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting
techniques, and if required - a lifting aid.
ATTENTION!
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez
des techniques de levage appropriées et, si nécessaire - un auxiliaire de levage
lors du retrait.
CAUTION!
SolarEdge inverters and power optimizers can be installed at a minimum
distance of 50 m/ 164 ft from the shoreline of an ocean or other saline
environment, as long as there are no direct salt water splashes on the inverter or
power optimizer.
 ATTENTION!

Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m
de la ligne d'eau de l'océan ou autre environnement salin, tant qu'il n'y a pas
d'éclaboussements d'eau salée directs sur l'onduleur.
1. Determine the inverter mounting location, on a wall, stud framing or pole. It is
recommended to mount the inverter in a location protected from direct sunlight.
2. To allow proper heat dissipation, maintain the following minimum clearance areas
between the inverter and other objects:
If installing a single inverter:
8" (20 cm) from the top of the inverter.
At least 4" (10 cm) from the bottom of the Safety Switch; if conduit entry
to the Safety Switch will be from the bottom, leave sufficient clearance
for the conduits as well.
4" (10 cm) from the right and left of the inverter. For easy access to the
fans , a larger clearance is recommended.
If installing multiple inverters:
Chapter 3: Installing the Inverter 37
Three Phase System Installation Guide MAN-01-00002-4.3