Installation Guide

NOTE

For single-phase inverters, use only copper conductors rated for a minimum of

75°C/167°F. For three-phase inverters, use only copper conductors rated for a minimum

of 90°C/194°F. For three-phase inverters where opposite polarity DC conductors are

routed in the same conduit, 1000V rated cables must be used.

NOTE

This inverter is provided with an IMI (Isolation Monitor Interrupter) for ground fault

protection.

NOTE

The symbol appears at grounding points on the SolarEdge equipment. This symbol is

also used in this manual.

IMPORTANT SAFETY INSTRUCTIONS

SolarEdge-Installation Guide MAN-01-00002-4.0