Installation Guide

Opening Conduit Knockouts

Thisstepmaybeperformedaftermountingtheinverter.

1. MovetheSafetySwitchandtheinverterON/OFFswitchtoOFF.

NOTE

When the Safety Switch is OFF (for example during maintenance) it may be locked to

prevent safety hazard:

1. Move the Safety Switch to the Lock position.

2. Insert the lock through the knob opening and lock.

2. LoosenthescrewsonthefrontcoveroftheSafetySwitch,asshownbelow:

Figure 12: Opening the Safety Switch cover

3. RemovetheSafetySwitchcover.

4. OpentheACandDCconduitknockouts:Theswitchhasknockoutslocatedatthebottom,

backandsidesoftheenclosure,eachwithtwosizes:¾''and1''.Openthenecessarypair

accordingtotheconduitsusedintheinstallation,takingcarenottointerferewithanyof

theinternalcomponents.AUnibitdrillmaybeused.

Figure 13: Safety Switch knockouts

Chapter 3: Installing the Inverter

SolarEdge-Installation Guide MAN-01-00002-4.0